DC2641A: 0.8 ~ 60V @ 10A, 16 ~ 100 V in


Demonstration circuit 2641A is a single output synchronous buck converter featuring the LTC7801EUFD in the 24-lead QFN package. The input voltage range is from 16V to 100V and the output is 12V/10A. The DC2641A is configured with a sense resistor for overcurrent protection. Inductor DCR current sensing is optional. The board has a lot of features including an optional onboard NMOS LDO for DRVCC, a switch-mode power supply for EXTVCC, jumper selectable 100% duty cycle operation in dropout, a mode selector pin that allows the converter to run in CCM, pulse-skip, adjustable burst clamp or default Burst Mode® operation, a PGOOD output voltage monitor and PLLIN for PolyPhase® operation.

The LTC®7801 is a high performance step-down switching regulator DC/DC controller that drives an all N-channel synchronous power MOSFET stage that can operate from input voltages up to 140V. Constant frequency current mode architecture allows a phase-lockable frequency of up to 850kHz. The low 40µA no-load quiescent current extends operating run time in battery-powered systems. OPTI-LOOP® compensation allows the transient response to be optimized over a wide range of output capacitance and ESR values. The LTC7801 features a precision 0.8V reference and power good output indicator. The output voltage can be programmed between 0.8V to 60V using external resistors


Manufacturer Analog Devices Inc.
Category AC/DC and DC/DC Conversion
Sub-Category DC/DC SMPS - Single Output
Eval Board Part Number DC2641A-ND
Eval Board Supplier Analog Devices Inc.
Eval Board Normally In Stock
Topology Step Down
Outputs and Type 1 Non-Isolated
Voltage Out: Factory Set 12 V
Current Out 10 A
Voltage In 16 ~ 100 V
Efficiency @ Conditions >95%, 48V in, 12V @ 2 ~ 10 A
Voltage Out Range 0.8 ~ 60 V
Features Current Foldback Protection
Over Current Protection
Over Voltage Protection
Power Good Output
Short Circuit Protection
Shutdown, Enable, Standby
Soft Start
Thermal Protection
Switching Frequency 50 ~ 900 kHz
Standby Current [Typical] 10 µA
Quiescent Current [Typical] 2.5 mA
Component Count + Extras 47 + 66
Internal Switch Yes
Design Author Linear Technology
Application / Target Market Automotive
Power: Industrial Power
Standby Current [Maximum]
Quiescent Current [Maximum]
Main I.C. Base Part LTC7801
Date Created By Author 2017-05
Date Added To Library 2018-03

Eval Board

Order a fully assembled board:

Quantity Available: 10