Bartek Technologies

Mailing Address: 22503 Utica Avenue, Punta Gorda, Florida 33980 USA
Design Services Contact: Carlos Barberis, (941)621-3388

Bartek Technologies Development Services include the following:

  • Analog & Digital Circuit design
  • Embedded firmware development for controller applications
  • CPLD and FPGA Verilog code development
  • Switch-mode & Linear Power Design Topologies
  • Synthesis & Design for high power / high voltage applications
  • Certified Microchip design partner since 2003

For additional information refer to web page at:
For more detailed information please visit:


  • Project Management/Logistics
    • FCC Certification
    • UL Certification

Development Tools

  • FPGA/Synthesis
    • Intel Quartus II
  • IDE/Compiler
    • CCS
    • Microchip MPLAB
  • Mechanical
    • AutoCAD
  • Other
    • National Instruments LabVIEW
  • Schematic/Board Layout
    • Altium
    • Cadence Allegro/Orcad
    • Mentor Graphics PADS
  • Simulation
    • Matlab/Simulink
    • Spice/Simulation

Industries Served

  • Consumer
  • Industrial
  • Medical


  • Microchip Design Partner

Collaborate with Digi-Key's Applications Engineering resources on TechForum

The listing of any of these providers in the Design Services Providers Network does not constitute or imply an endorsement, sponsorship, or recommendation by Digi-Key of the third party, its Web site, or the information or services available from those sources or that it is suitable for your needs. Digi-Key is not responsible for the services or information obtained from any of these sources. This information is provided as a convenience for users of the Digi-Key web site. You must make your own decision based on your independent review regarding your interactions or communications with any of these providers.