SuperSpeed USB 3.0 Product



Texas Instruments' SuperSpeed USB 3.0 is ten times faster than USB 2.0

Texas Instruments SuperSpeed USB 3.0 Product Texas Instruments' SuperSpeed USB is the next evolution of the most successful PC-centric interconnect of all time. SuperSpeed USB utilizes dual simplex data transmission at a bit rate of 5 Gbps. While USB 2.0 high-speed (and even USB full-speed, 12 Mbps and low-speed, 1.5 Mbps) are more than adequate for many applications, there are many applications for which the USB connections are becoming the bottleneck. The main application focus is to enhance the Sync-n-Go experience of end-users with their content-rich consumer peripheral devices. The 5 Gbps data rate should provide headroom for the next five years.

Buy Now
Photo Digi-Key
Part Number
Description
TUSB7340 Photo IC
296-29070-1-ND
SuperSpeed USB 4-Port xHCI Host Controller
The TUSB7340 is a USB 3.0 xHCI compliant host controller that supports up to four downstream ports. The TUSB7340 interfaces to the host system via a PCIe x1 Gen 2 interface and provides SuperSpeed,high-speed, full-speed, or low-speed connections on the downstream USB ports. It is available in a pin-compatible 100-pin RKM package. TUSB7340 Datasheet
Eval Board
296-29220-ND
TUSB7320 Photo IC
296-29069-1-ND
SuperSpeed USB 2-Port xHCI Host Controller
The TUSB7320 supports up to two downstream ports. The TUSB7320 interfaces to the host system via a PCIe x1 Gen 2 interface and provides SuperSpeed, high-speed, full-speed, or low-speed connections on the downstream USB ports. It is available in a pin-compatible 100-pin RKM package. TUSB7320 Datasheet
Eval Board
296-29881-ND
TPD2EUSB30 Photo ICs
296-28153-1-ND
296-25509-1-ND
2-Channel ESD Solution for SuperSpeed (6 GBPS) USB 3.0 Interface
The TPD2EUSB30 and TPD2EUSB30A provide 2 channel ESD and surge protection solutions in space saving, flow-through packages. These devices have been designed to protect sensitive components which are connected to ultra high-speed data and transmission lines. These devices also offer 5 A (8/20 µs) peak pulse current ratings per IEC 61000-4-5 (lightning) specification. TPD2EUSB30 Datasheet
TUSB9261 Photo IC
296-28827-ND
2nd Generation SuperSpeed USB 3.0 to Serial ATA Bridge
The TUSB9261 is an ARM cortex M3 microcontroller based USB 3.0 to serial ATA bridge. It provides the necessary hardware and firmware to implement a USB attached SCSI protocol (UASP) compliant mass storage device suitable for bridging hard disk drives (HDD), solid state disk drives (SSD), optical drives and other compatible SATA 1.5 Gbps or SATA 3.0 Gbps devices to a USB 3.0 bus. TUSB9261 Datasheet
Eval Board
296-29882-ND
TUSB8040 Photo IC
296-29337-ND
SuperSpeed USB (USB 3.0) 4-port Hub Controller
The TUSB8040 is a USB 3.0 compliant hub available in an 80-pin QFP or 100-pin QFN package. The QFP device is designed for operation over the industrial temperature range of -40°C to 85°C. The QFN device is designed for operation over the commercial temperature range of 0°C to 70°C. TUSB8040 Datasheet
Eval Board
296-29223-ND
TUSB1310A Photo IC
296-28131-ND
SuperSpeed USB Transceiver with PIPE3 and ULPI Interfaces
The TUSB1310A is a single port, 5.0 Gbps USB 3.0 physical layer transceiver operating off of a single reference clock provided by either a crystal or an external reference clock. The reference clock frequencies are selectable from 20, 25, 30, and 40 MHz. The TUSB1310A provides the clock to the USB controller.
TUSB1310A Datasheet
SN65LVPE502CP Photo IC
296-28367-1-ND
Dual Channel USB 3.0 Redriver/Equalizer
The SN65LVPE502CP is a dual channel, single lane USB 3.0 redriver and signal conditioner supporting data rates of 5.0 Gbps. The device complies with USB 3.0 spec revision 1.0, supporting electrical idle condition and low frequency periodic signals (LFPS) for USB 3.0 power management modes. SN65LVPE502CP Datasheet
Eval Board
296-29883-ND