DRV8830 Motor Driver



Texas Instruments DRV8830 Motor Driver

Texas Instruments' low-voltage motor driver with
serial interface

Texas Instruments' DRV8830 provides an integrated motor driver solution for battery-powered toys, printers, and other low-voltage or battery-powered motion control applications. The device has one H-bridge driver, and can drive one DC motor or one winding of a stepper motor, as well as other loads like solenoids.

The output driver block consists of N-channel and P-channel power MOSFET’s configured as an H-bridge to drive the motor winding. Provided with sufficient PCB heatsinking, the DRV8830 can supply up to 1 A of continuous output current. It operates on power supply voltages from 2.75 V to 6 V.   DRV8830 Datasheet

  Features   Applications
  • H-bridge voltage-controlled motor driver
    • drives DC motor, one winding of a stepper motor, or other actuators/loads
    • efficient PWM voltage control for constant motor speed with varying supply voltages
    • low MOSFET on-resistance: HS + LS 450 mΩ
  • 1 A maximum continuous drive current
  • 2.75 V to 6 V operating supply voltage range
  • 300 nA (typical) sleep mode current serial I²C-compatible interface
  • Multiple address selections allow up to nine devices on one I²C bus
  • Current limit circuit and fault output
  • Thermally enhanced surface mount packages
  • Battery-powered:
    • Printers
    • Toys
    • Robotics
    • Cameras
    • Phones
  • Small actuators, pumps, etc.

Texas Instruments
Part Number
Digi-Key
Part Number
Packaging Current -
Output
Voltage -
Load
Package  
DRV8830DGQR 296-28165-2-ND Tape & Reel 1 A 2.75 V ~
6 V
10-TFSOP, 10-MSOP
(0.118", 3.00 mm width)
exposed pad
DRV8830 Datasheet
296-28165-1-ND Cut Tape
296-28165-6-ND Digi-Reel®